Description:

    The SAPAC F-22 resembles the famous and very advanced Raptor Jet. The SAPAC F-22 exemplifies the same beautiful lines as the original fighter jet. The wing and body used in this F-22 are specially designed to allow high G maneuvers, yet keep a very low wing load. The F-22 is a stable aircraft with excellent performance. Designed with twin ducted fans with brushless motors, the F-22 has great performance and power. You can fly any aerobatic trick desired and the power system designed for the F-22 provides the capability to fly it in more than low to moderate wind conditions. The F-22 is controlled with a 4-channel R/C system. On the ground you have control of the steerable nose gear, in the air you have speed, ailerons, elevator and no rudder. The large capacity and high rate LiPo battery provides exuberant energy and because it features a safeguard, it is impossible to discharge your battery excessively.

Specifications:

• Fuselage Total Length : 44"
• Wingspan : 31.6"
• Main Wing Area : 3.982sq.ft
• Wing Loading : 0.952oz/sq.ft
• Flying Weight : 35.273oz
• Power : EDF64X2
• Thrust : 37.037oz
• Color Box Dimension : 44.6" X 13" X 9"
• Carton Dimension : 45" X 19" X 26" (4 color box per carton)
• Transmitter : 4 channels (Not included.)
• Receiver : Mini 6 channels (Not included.)
• Servo : 8g servo
• ESC : 25A
• Motor : Outrunner 2830, KV3800
• Battery : 3S 3000MAH 15C
• Fan : Two, 6 paddle 64MM Electric Ducted Fans

What's in the box?

Aircraft: Pre-painted fuselage in USAF Thunderbirds motif, wing and control surfaces; pre-attached decals, instructions, landing gear, styrofoam-safe adhesive, though we recommend using 12 minute epoxy instead. (Please see below.)

Mechanical/Electronics: Engines, fans and all electronics are pre-installed, lithium-polymer battery.

*Note : This aircraft is set up the same as the RTF version but without the receiver and transmitter.

What's needed to complete?

• Four channel transmitter.
• Compatible receiver.
• Instead of using regular glue for construction, we recommend using 12 minute epoxy for maximum strength and durability in high-g maneuvers.
• Aircraft requires minimal assembly: simply glue the wings and control surfaces on, mount the landing gear, install the batteries. Receiver not included and must be supplied by the modeler. Servos are pre-installed, simply plug connectors into your receiver. The canopy fastens on to eight magnetic attachment points for easy access.

Additional Information:

• The Center of Gravity is located 100mm - 110mm back from the leading edge of the wing. This can be found just in front of the finger holes on the bottom of the fuselage. To find it, measure along the fuselage with the aircraft inverted.